![Utilimaster REACH Service Manual Download Page 151](http://html.mh-extra.com/html/utilimaster/reach/reach_service-manual_1065305151.webp)
Utilimaster Corporation attempts to provide
information that is accurate, complete, and
useful. All information contained in this
manual is based on the latest product infor-
mation available at the time of publication.
However, because of the Utilimaster policy
of continual product improvement, Utilimas-
ter reserves the right to amend the informa-
tion in this document at any time without
prior notice.
This material is confidential and the prop
-
erty of Utilimaster. It is shared with your
company for the sole purpose of helping you
with the operation of the described equip-
ment.
Utilimaster makes no warranty of any kind
with regard to this material, including, but
not limited to, the implied warranties of
merchantability and fitness for a particular
purpose. Utilimaster shall not be liable for
errors contained herein or for incidental or
consequential damages in connection with
the furnishing, performance, or use of this
material.
Utilimaster expressly disclaims all respon-
sibility and liability for the installation, use,
performance, maintenance, and support of
third-party products. Customers are advised
to make their independent evaluation of such
products.
No part of this document may be photo-
copied, reproduced, or translated to another
language without the prior written consent
of Utilimaster.
Utilimaster Corporation attempts to provide
information that is accurate, complete, and
151
For Assistance Call: 800-237-7806
Parts On-line:
https://parts.utilimaster.com
Reach—Body Service Manual
Fax: 574-862-7637
Lights
Grommet-mounted
Grommet-mounted lights are used in a variety of areas including: back-up lights, rear turn lights, cab
and cargo dome lights, and brake lights. Bullet lights, mini-marker lights, and 4" round lights are all
grommet-mounted lights.
Removal
NOTE: To remove the 4" round light, insert a flat-blade
screwdriver between the light and rubber grommet to
separate the light from the grommet. To remove all other
lights, push light out through front of grommet.
NOTE: To ease in the removal and installation process,
lightly spray the grommet and light with soapy water.
1. Turn off ignition and all lights.
2. Remove light from grommet.
3. Disconnect wire harness from light and set aside.
4. Remove and replace grommet if necessary.
Installation
1. Install grommet.
2. Connect wire harness to light.
3. Push light carefully through the front of the grommet.
Headlights
Adjustment
NOTE: If no headlight-aiming tool is available, perform steps 8–11 as a temporary solution
until a properly calibrated headlight-aiming tool can be obtained.
1. Turn off ignition.
2. Remove any load from the vehicle.
3. The vehicle should have approximately a half tank of fuel.
4.
Check that the tires are properly inflated to the tire manufacturer's recommended inflation.
5. Check headlights to ensure they are clean.
6. Park on level surface.
CAUTION: The slit on the rear of the grommet must be pointed down to allow water to drain.
Place screwdriver between light and grommet.
Marker light