Utilimaster Corporation attempts to provide
information that is accurate, complete, and
useful. All information contained in this
manual is based on the latest product infor-
mation available at the time of publication.
However, because of the Utilimaster policy
of continual product improvement, Utilimas-
ter reserves the right to amend the informa-
tion in this document at any time without
prior notice.
This material is confidential and the prop
-
erty of Utilimaster. It is shared with your
company for the sole purpose of helping you
with the operation of the described equip-
ment.
Utilimaster makes no warranty of any kind
with regard to this material, including, but
not limited to, the implied warranties of
merchantability and fitness for a particular
purpose. Utilimaster shall not be liable for
errors contained herein or for incidental or
consequential damages in connection with
the furnishing, performance, or use of this
material.
Utilimaster expressly disclaims all respon-
sibility and liability for the installation, use,
performance, maintenance, and support of
third-party products. Customers are advised
to make their independent evaluation of such
products.
No part of this document may be photo-
copied, reproduced, or translated to another
language without the prior written consent
of Utilimaster.
Utilimaster Corporation attempts to provide
information that is accurate, complete, and
For Assistance Call: 800-237-7806
Visit us at:
www.utilimaster.com
174
Reach—Body Service Manual
E-mail:
Pine-Tree Fastener
Removal
1. Use a center punch (or an air hammer with a punch attachment) to place a hole in the center of
the head of the fastener.
2. Drill out the head of the fastener using an F-drill bit.
3. Use a center punch to knock out the center pin.
Installation
Use a rubber mallet to install the pine-tree fastener.
Pin-and-Collar Fastener (Magna-Grip
®
)
Removal
NOTE: Use low-RPM drill speed to avoid overheating the
pin.
From
either side
, use a die grinder to cut off the rivet. Or from the
head side
, use the appropriate-size drill bit (3/16" [5 mm], 1/4" [6
mm], or 3/8" [10 mm]), to
drill off the head
of the pin. Punch out
the center of the remaining pin.
Installation
Use a Huck
®
rivet gun to replace it.
If a Huck rivet gun is not available, replace the fastener with a Grade
8 bolt and locknut of like diameter. For additional locking capacity,
use Loctite thread locker.
NOTE: Flat washers are required against aluminum surfaces.
Scrivet
Removal
Use a Phillips head screw driver to remove. If necessary use a flat blade screwdriver
to lift out scrivet.
Installation
Gently push in to install.
(With collar)
Magna-Grip
®
(With flanged collar)
Scrivet