Utilimaster Corporation attempts to provide
information that is accurate, complete, and
useful. All information contained in this
manual is based on the latest product infor-
mation available at the time of publication.
However, because of the Utilimaster policy
of continual product improvement, Utilimas-
ter reserves the right to amend the informa-
tion in this document at any time without
prior notice.
This material is confidential and the prop
-
erty of Utilimaster. It is shared with your
company for the sole purpose of helping you
with the operation of the described equip-
ment.
Utilimaster makes no warranty of any kind
with regard to this material, including, but
not limited to, the implied warranties of
merchantability and fitness for a particular
purpose. Utilimaster shall not be liable for
errors contained herein or for incidental or
consequential damages in connection with
the furnishing, performance, or use of this
material.
Utilimaster expressly disclaims all respon-
sibility and liability for the installation, use,
performance, maintenance, and support of
third-party products. Customers are advised
to make their independent evaluation of such
products.
No part of this document may be photo-
copied, reproduced, or translated to another
language without the prior written consent
of Utilimaster.
Utilimaster Corporation attempts to provide
information that is accurate, complete, and
For Assistance Call: 800-237-7806
Visit us at:
www.utilimaster.com
26
Reach—Body Service Manual
E-mail:
Cladding
Front Fender
Removal
1. Remove three screws in wheel liner.
2. Remove M6 nut from stud that is attached to the fender.
The nut is located inside the engine compartment.
3. Remove two M6 nuts from studs that are attached to
fender. These nuts are located above the wheel liner.
4. Remove two M6 screws from cladding at front door post.
5. Lift cladding out of channel and set aside.
Installation
1. Set cladding onto channel.
2. Secure cladding at front door post with two M6 screws.
3. Secure cladding above wheel liner with two M6 nuts.
4. Secure cladding inside engine compartment
with one M6 nut.
5.
Torque to 7–8 ft•lbs.
6. Secure wheel liner with three screws.
CAUTION: Discard ALL used fasteners and replace with new. If using a fastener that does NOT have
preapplied thread lock, apply a medium-grade liquid thread lock.
Nut location inside engine compartment
Screw locations in doorway
Nut locations above wheel liner
Screw locations in wheel liner