Sageon III Power System
Configuration and Operation
PM990-8800-00, Rev. 9
4-7
4.5 HOME MENU SCREENS
With the Home screen displayed, pressing the “up arrow” or “down arrow” button will move through a series of screens showing
ambient temperature, a series of editable parameters (e.g. float voltage high and low, security, number of batteries), and enabling and
disabling of auxiliary parameters (e.g. battery cell voltage monitoring). The following map summarizes the available menu screens.
Home Screen
System current, voltage and mode
Ambient temperature
3-Phase AC Monitor option
Programmab
Ambient temperature alarm
Voltage, high alarm
Voltage, low alarm
Failsafe Alarms: on/off
Bat Cur Sensor: on/off
Security: on/off
Password setup
When viewing another
Test indicators
screen, the Home
Number of Rectifiers (SMRs)
screen will reappear
Number of battery strings connected
in ~60 seconds if no
Full scale battery current
button is pressed.
Load sensor on/off
FS Load Current
Access code (7 digit number)
Date format
Date/time set
Alarm report: on/off
Daily report: on/off
Daily report time
Modem on/off
Phone numbers 1, 2, and 3
Audio alarm: on/timeout/off
Cct input: no/nc/disable*
Battery switch: no/nc/disable*
LVDS: no/nc/disable*
Auxiliary units, press ENTER
1-ph AC monitor: on/off
3-ph AC monitor: on/off
Sageon III Battery Monitor: on/off
Battery configuration
Number of batt strings monitored
Cell voltage high/low/differential
Site monitor, press ENTER
Outputs 1-4, on/off status
*no = normally open; nc = normally closed
Note:
The screen examples in this and subsequent sections will vary with System voltage, loads, environment, battery quantity, type,
and condition, included System options, and other factors.
Note:
Screens for options will not be viewable unless the option is installed and/or enabled.
