UniData Communication Systems UNIFIBER GIGAROUTER UF72N, User Manual

Page: 84 / 210

Gigarouter
UF72N User Manual
Page 76 of 203
Figure 3-118 Configure FXS Parameters
The following items are displayed on this screen:
► Min Flash Detect Time: The minimum time to detect the flash.
► Max Flash Detect Time: The maximum time to detect the flash.
► Flash Key Enable: Whether to enable digit detect after flash.
► Switch&Release Call: If the digit specified is detected after flash, terminate the active call and
recover the call on hold.
► Three Party Call: If the digit specified is detected after flash, enter the conference mode.
► Reject Key: If the digit specified is detected after flash, reject the call on hold.
► Switch Call Key: If the digit specified is detected after flash, hold the active call and
recover the call on hold.
► Keep the hold call when onhook: If selected, when hanging up in this context, the telephone rings
to notify the user there is still a call on hold.
► (#)Quick Dial Key: Whether to send telephone number immediately after receiving the # key.
► Asterisk Func Key: Whether to use the ‘*’ key as flash key.
► Tap Report: Whether to report an event to server when flash detected.
► Escape Seq: Whether to use an escape characters when sending special DTMF.
► CID Enable: Whether to enable caller id globally.
► Callee Inverse Polarity: Whether to activate the Polarity Reversal for FXS callee.
► Caller Inverse Polarity: Whether to activate the Polarity Reversal for FXS caller.
3.5.9 Centrex
To control call each other of internal number in the same device, choose the menu
VOIP Service → Centrex to load the following page.