UniData Communication Systems UNIFIBER GIGAROUTER UF72N, User Manual

Page: 126 / 210

Gigarouter
UF72N User Manual
Page 118 of 203
Figure 4-42
Configure Basic Settings
The following items are displayed on this part.
► Enable WiFi: Enable or disable the WIFI AP function globally.
► Channel: This field determines which operating frequency will be used. The default channel
is set to AutoSelect , so the AP will choose the best channel automatically. It is
not necessary to change the wireless channel unless you notice interference
problems with another nearby access point.
► Wireless Mode: Select the desired mode.
11b: Select if all of your wireless clients are 802.11b.
11g: Select if all of your wireless clients are 802.11g.
11n: Select only if all of your wireless clients are 802.11n.
11b/g: Select if you are using both 802.11b and 802.11g wireless clients.
11b/g/n: Select if you are using a mix of 802.11b, 11g and 11n wireless clients.
► Channel Width: Select any channel width from the drop-down list. The default setting is automatic,
which can automatically adjust the channel width for your clients. If you choose to
11n or 11b/g/n Wireless mode , this configuration is required. Two values of
width are provided: 20MHz and 20/40MHz .
The
Service Set Identifier (SSID) is used to identify an 802.11 (Wi-Fi) network and it’s discovered by
network sniffing/scanning. GIGAROUTER UF72N provides up to four SSID.
► Enable SSID: Enable or disable this entry of SSID. SSID1 can’t be disabled.
► SSID Name: Enter the name of SSID. The name of SSID must be unique in all wireless
networks nearby.
► Bind Interface: Select a network interface to be bridged to the SSID.
► Enable Broadcast: When wireless clients survey the local area for wireless networks to associate
with, they will detect the SSID broadcast by the device. If you select the
Enable Broadcast checkbox, the device will broadcast its name (SSID) on