UniData Communication Systems UNIFIBER GIGAROUTER UF72N, User Manual, Page: 147 / 210

Gigarouter
UF72N User Manual
Page 139 of 203
Figure 4-73 Show Telnet Access Control Information
The command “set network-access-ctrl telnet” configures the telnet access control parameters as below:
Figure 4-74 Configure Telnet Access Control Parameters
The following items are displayed on this screen:
►
Port: Port when using telnet tools access device.
Internet Telnet Access:
►
Allow Access: If enabled, allow access to the device from the Internet via telnet.
►
IP Limit: If enabled, allow only specific IP range to access the device from the Internet via
telnet
►
IP Range: If IP Limit enabled, specifies the IPv4 address range that only allow access to the
device from the Internet via telnet.
►
IPv6 Range: If IP Limit enabled, specifies the IPv6 address range that only allow access to the
device from the Internet via telnet.
Intranet Telnet Access:
►
Allow Access: If enabled, allow access to the device from the Intranet via telnet.
►
IP Limit: If enabled, allow only specific IP range to access the device from the Intranet via
telnet
►
IP Range: If IP Limit enabled, specifies the IPv4 address range that only allow access to the
device from the Intranet via telnet.
►
IPv6 Range: If IP Limit enabled, specifies the IPv6 address range that only allow access to the