Ulvac GI-M2, Instruction Manual

Page: 39 / 101

33
8.12.Selection of Analog Function
→
Refer to
Ｐ．
41
Setting of analog function. The set point as follows.
GI-M2 GI-D7 GI-N8
ｒＥＣ：１
Eeach-digit linear output mode
ｒＥＣ：２
Pseudo-logarithmic mode
ｒＥＣ：３
Range hold liniea mode
ｒＥＣ：４
logarithmic mode
GI-D6 compatibility output mode Not used
ｒＥＣ：
5 Not used GI-TL3 compatibility output mode Not used
ＲＥＣ－①
The
○
portion in the left figure blinks
after the segment indicator displays [
ｒＥＣ
＿＿
] for about 1 second. Each time the [
∆
]
key is pressed, the
○
portion of the
segment indicator in the left figure displays
[
ｒＥＣ ＿１
]
⇒
[
ｒＥＣ ＿２
]
⇒
[
ｒＥＣ ＿
３
]
⇒
[
ｒＥＣ ＿１
]
・・
cyclically.
To use recorder LIN(LOG), press the [
⇒
(ENTER)] key, with [
ｒＥＣ ＿１
]
selected, to transfer control to the BPS-
①
status.
To use analog REC-HOLD, press the [
⇒
(ENTER)] key, with [
ｒＥＣ ＿３
]
selected, to transfer control to the REC-
②
status.
8.13. Setting of Analog Function
→
Refer to
Ｐ．
41
Set the REC-HOLD numeric values. The set point as follows.
GI-M2 GI-D7 GI-N8
Setting
range
－０ ～ －８ －１ ～ －７ －１ ～ －９
Settable numeric values are sensitivity factor N2. This setting range will change if a
sensitivity factor other than N2 is designated or if sensitivity setting is entered.
ＲＥＣ－②
Each time the [
∆
] key is pressed, the
numeric value of the blinking portion
changes. When a desired value is
displayed, press the [
⇒
(ENTER)] key to
transfer control to the BPS-
①
status.