Tyco Electronics F08, Installation & Programming Manual

Page: 23 / 100

Document No: LT0082 F08 Installation & Programming Manual
FIP Installation
2.5 BATTERY INSTALLATION
Install only compatible batteries (refer Appendix A) in the bottom of the FIP cabinet. Using
the battery cables supplied, connect wiring as shown in Figure 2.6.
* * NOTES * *
(a) The F08 system should be system tested before connecting the batteries.
(b)
If the batteries are located remotely from the F08, a battery protection device
(> 3 Amps) must be located at the batteries.
(c)
USE ONLY THE BATT+ & BATT- TERMINALS PROVIDED. PARALLEL
CONNECTION OF BATTERIES IS NOT PERMITTED.
PLEASE OBSERVE POLARITY
│ │ Q ││ 0V │
│ ├─┤│ │
╔═══╪════╡ Q ││ BATT
+
│
║ │ ├─┤│ │
╔══════════╡ Q ││ BATT
-
│
║ ║ │ ├─┤│ │
║ ║ │ │ Q ││ EARTH │
║ ║ │ └─┴┘ F08 MAIN BOARD │
║ ║ ────────────────────────────────────────────────────────────┘
║ ║ ────────────────────────────────────────────────────────────┐
║ ║ │ │
║ ║ │ HEATSINK │
║ ║ │ │
║ ╚════════════════════════════════════════════════════════════════╗
║ ║
║ ┌─────────────┐ ┌───────────┐ ║
║ BLACK │ │ │ │ RED ║
║ │ │ │ │ ║
║ │ │ │ │ ║
║ │ TRANSFORMER │ │ MAINS │ ║
║ │ │ │ SWITCH │ ║
║ ┌──────────────┐ │ │ │ │ ┌──────────────┐ ║
║ │ ┌─┐ ┌─┐ │ │ │ │ │ │ ┌─┐ ┌─┐ │ ║
║ │ ███ - + ███ │ │ │ │ │ │ ███ - + ███ │ ║
║ │ ███ ███ │ └─────────────┘ └───────────┘ │ ███ ███ │ ║
║ │ ║ ║ │ │ ║ ║ │ ║
║ │ ║ ║ │ │ ║ ║ │ ║
║ │ ║ ║ │ │ ║ ║ │ ║
╚════╝ ╚══════════════════════════════════════╝ ╚════╝
│ │ │ │
│ │ │ │
│ │ │ │
│ BATTERY │ │ BATTERY │
│ 12V │ │ 12V │
│ │ │ │
└──────────────┘ └──────────────┘
════════════════════════════════════════════════════════════════════
Figure 2.6
Battery Connections
Issue 3.04 24 March 2006 Page 2-11