F08 Installation & Programming Manual
Document No: LT0082
FIP Installation
2.13
DISPLAY & ZONE LABELLING
2.13.1 ZONE
NAMING
LABEL
The F08 Zone Labelling can be simply done on a typewriter or word-processor.
Note:
For a typewriter use a photocopy of the label supplied with the panel or
provided in Appendix A.3.
The type format is:
6 lines per inch.
30 characters at 10 CPI or 36 characters at 12 CPI
Two and a half (2.5) lines between each zone window.
To install the Zone Naming label, loosen the four left hand-side screws that hold the Display
Assembly onto the inner door. Insert the zone label behind the Keyboard mylar and adjust
such that the zone labelling is aligned correctly. Fasten the four screws.
2.13.2
DISPLAY BOARD REMOVAL OR INSTALLATION
The F08 Display Board is attached to the rear of the internal door by five M4 x 12mm screws
and flat washers.
To remove the display board simply unplug the display FRC from J1 on the Main Board, then
remove all 5 screws.
Reverse the process to install the display board.
2.13.3 MYLAR
REPLACEMENT
To replace the Keyboard Mylar requires the front six Phillips-Head screws on the inside door
to be removed, leaving the center two to last.
The Display Board assembly has to be held whilst replacing the Mylar.
Replace the center two screws first and adjust the Mylar such that LEDs are aligned
correctly. Fasten the two center screws first, then all other screws.
Page 2-34
24 March 2006
Issue 3.04
Summary of Contents for F08
Page 48: ......
