14
Setting of test condition for withstanding voltage test
8.2
●
Referential voltage
Adjustable range: 0.00~5.00kV,OFF
[When turning OFF the setting of referential voltage]
To enter setting mode
①
In READY status, press
or
key, then the test mode lamp blinks. The test
mode lamp moves up and down with
▲
or
▼
key. Make the required test
mode lamp blinking (
AC
or
DC
).
②
Press
or
key and make the test mode lamp lit up.
To turn OFF the setting of referential voltage
①
Press
or
key and select the status that the test voltage display blinks.
②
Next, press
ON/OFF
key and select the status that the display blinks with
(refer to the above figure).
To return to the previous setting
Press
key, then the setting changes to the
setting of test range of withstanding
voltage test
.
To the next setting
Press
key, then the setting moves to the
setting of high limit of leak current
.
Finish of setting
Press
ENTER
key, then the tester returns to READY status, memorizing the settings
having been made.
When the
EXIT
key (
SHIFT
and
ENTER
key at a time) is pressed in the setting
mode, the setting mode for the test condition is interrupted and the tester becomes
READY
status.
The test conditions in this case are those before entering the setting mode of test
condition.
ON/OFF
ENTER
WRITE
READ
LOCK
EXIT
SHIFT
BUZZER
PROTECT
○
ONLINE
○
○
○
○
○
KEY LOCK
DISCHARGE
REMOTE
READY
AC
DC
○
No.
s
mA
SET
SET
LOW
HIGH
GOOD
LOW
MODE
JUDGE
CURRENT
TEST VOLTAGE
MEMORY
RANGE
TIME
kV
kV
DC
AC
HIGH
●
