Tripp Lite NGI-S08C2POE8, Owner'S Manual

Page: 65 / 157

65
format.
enable configure terminal This command changes the node to configure node.
configure igmp-snooping (disable
| enable)
This command disables / enables the IGMP
snooping on the switch.
configure igmp-snooping vlan
VLANLISTS
This command enables the IGMP snooping function
on a VLAN or range of VLANs.
configure no igmp-snooping vlan
VLANLISTS
This command disables the IGMP snooping function
on a VLAN or range of VLANs.
configure igmp-snooping
unknown-multicast
(drop|flooding)
This command configures the process for unknown
multicast packets when the IGMP snooping function
is enabled.
drop : Drop all of the unknown multicast packets.
flooding : Flooding the unknown multicast packets to
all ports.
4.6.1.4. IPv4 Settings
IPV4 Settings is used to configure the switch management IP by static or DHCP Client
Default Settings
The default DHCP client is disabled.
The default Static IP is 192.168.0.254
Subnet Mask is 255.255.255.0
Default Gateway is 0.0.0.0
4.6.1.4.1. CLI Configuration
Node Command Description
enable ping IPADDR [–c
COUNT]
This command sends an echo request to the
destination host. The –c parameter allow user to
specific the packet count. The default count is 4.
enable ping IPADDR [–s SIZE] This command sends an echo request to the
destination host. The –s parameter allow user to
specific the packet size. Valid range: 0 ~ 1047
bytes.
enable ping IPADDR [–c
COUNT –s SIZE]
This command sends an echo request to the
destination host. The –c parameter allow user to
specific the packet count. The default count is 4.
The –s parameter allow user to specific the packet
size. Valid range: 0 ~ 1047 bytes.
enable ping IPADDR [-s SIZE –c
COUNT]
This command sends an echo request to the
destination host. The –c parameter allow user to
specific the packet count. The default count is 4.
The –s parameter allow user to specific the packet
size. Valid range: 0 ~ 1047 bytes.
enable configure terminal This command changes the node to configure node.
configure interface eth0 This command enters the eth0 interface node to
configure the system IP.
eth0 show This command displays the eth0 configurations.
eth0 ip address A.B.C.D/M This command configures a static IP and subnet
mask for the system.