Tripp Lite NGI-S08C2POE8, Owner'S Manual

Page: 14 / 157

14
To properly connect fiber cabling : Check that the fiber terminators are clean. You can clean the
cable plugs by wiping them gently with a clean tissue or cotton ball moistened with a little
ethanol. Dirty fiber terminators on fiber optic cables will impair the quality of the light
transmitted through the cable and lead to degraded performance on the port.
Note: When inserting the cable, be sure the tab on the plug clicks into position to ensure that it
is properly seated.
Check the corresponding port LED on the Switch to be sure that the connection is valid. (Refer
to the LED chart).
3.2. Installation
The location chosen for installing the Switch may greatly affect its performance. When
selecting a site, we recommend considering the following rules:

Install the Switch in an appropriate place. See Technical Specifications for the
acceptable temperature and humidity ranges.

Install the Switch in a location that is not affected by strong electromagnetic field
generators (such as motors), vibration, dust, and direct sunlight.

Leave at least 10cm of space at the front and rear of the unit for ventilation.
Attention:
The SEN-8424PL is an open type device and SEN-8424PL shall be DIN-Rail
mounted or wall mounted (optional) in cabinet or enclosure
Hardware Installation

Step1 : Unpack the device and other contents of the package.

Step 2 : Fasten DIN-Rail kit on the rear of the NGI-S08C2POE8.

Step 3: Connect the 24VDC power to the power terminal block.

Step 4 : Connect the Ethernet (RJ45) port to the networking device and check the LED
status to confirm the connection is established.
DIN Rail Installation
The NGI-S08C2POE8 has a DIN rail bracket on the back of the Switch.
Location: The NGI-S08C2POE8 can be DIN-Rail-mounted in cabinet or enclosure.
Mounting the Switch:
Place the NGI-S08C2POE8 on the DIN rail from above using the slot. Push the front of the
switch toward the mounting surface until it snaps into place with a click sound.