Tripp Lite NGI-S08C2POE8, Owner'S Manual

Page: 58 / 157

58
configure interface range
gigabitethernet1/0/
PORTLISTS
This command enters the if-range configure node.
if-range spanning-tree
(disable|enable)
This command configures enables/disables the STP
function for the specific port.
4.5.2.1.2.
Ｗ
eb Configuration
Parameter Description
STP Settings
State
Select
Enabled
to use Spanning Tree Protocol (STP) or Rapid
Spanning Tree Protocol (RSTP).
Mode
Select to use either Spanning Tree Protocol (STP) or Rapid Spanning
Tree Protocol (RSTP).
STP Parameter Settings
Forward Delay
This is the maximum delay time (in seconds) the Switch will wait
before changing states. This delay is required because every switch
must receive information about topology changes before it starts to
forward frames. In addition, each port needs time to listen for
conflicting information that would make it return to a blocking state;
otherwise, temporary data loops might result. The allowed range is 4
to 30 seconds.
Max Age
This is the maximum time (in seconds) the Switch can wait without
receiving a BPDU before attempting to reconfigure. All Switch ports
(except for designated ports) should receive BPDUs at regular
intervals.
Any port that ages out STP information (provided in the last BPDU)
becomes the designated port for the attached LAN. If it is a root port,