42
4.4.2.1.
CLI Configuration
Node
Command
Description
enable
show loop-detection
This command displays the current loop detection
configurations.
enable
configure terminal
This command changes the node to configure node.
configure loop-detection
(disable|enable)
This command disables / enables the loop detection
on the switch.
configure loop-detection address
MACADDR
This command configures the destination MAC for
the loop detection special packets.
configure no loop-detection
address
This command configures the destination MAC to
default (00:0b:04:AA:AA:AB).
configure interface IFNAME
This command enters the interface configure node.
interface
loop-detection
(disable|enable)
This command disables / enables the loop detection
on the port.
interface
no shutdown
This command enables the port. It can unblock port
blocked by loop detection.
interface
loop-detection recovery
(disable|enable)
This command enables / disables the recovery
function on the port.
interface
loop-detection recovery
time <1-60>
This command configures the recovery period time.
configure interface range
gigabitethernet1/0/
PORTLISTS
This command enters the if-range configure node.
if-range
loop-detection
(disable|enable)
This command disables / enables the loop detection
on the ports.
if-range
loop-detection recovery
(disable|enable)
This command enables / disables the recovery
function on the port.
if-range
loop-detection recovery
time <1-60>
This command configures the recovery period time.
Example:
L2SWITCH(config)#loop-detection enable
L2SWITCH(config)#interface 1/0/1
L2SWITCH(config-if)#loop-detection enable
Summary of Contents for NGI-S08C2POE8
Page 1: ......
Page 22: ...22...
Page 138: ...138 Action Click Delete to remove a configured trap receiver station...
