TRADEDOR TD55DM, Installation Manual

Page: 14 / 40

Tradedor TD55DM & TD55SEL Installation Guide
13
1 Open the lid of the receiver box by unscrewing the
four screws (one in each corner)
(fig.8.1).
2 Remove the two screws from the bottom of the box
(these can be found behind the glands) and the wall
mounting plate can be removed from the back
(fig.8.2 & fig.8.3) .
3 Making sure the fixing plate is square with the screw
fixings at the bottom, mark the four fixings points.
This should be at a comfortable height to operate the
push buttons but out of the easy reach of children
- between 1500mm from the floor and 300mm down
from the roof/ceiling is recommended. Drill and then
secure in place
(fig.8.4) .
4 Hook the top of the receiver box on to the wall fixing
plate with the cable glands pointing downwards and
secure with the two screws.
5 Remove the green 5 terminal block in the bottom left
corner
(fig.8.5) and you will see letters printed on the
circuit board.
6 Wiring as follows:
Mains Power:
N – Neutral / Blue 3 core cable (power)
L – Live / Brown 3 core cable (power)
Earth – connect power cable directly to earth from
motor in plastic connector.
Motor:
U – Brown 4 core cable (motor)
V – Black 4 core cable (motor)
Earth - connect motor cable directly to earth from
motor in plastic connector.
W(c) – Blue motor cable (4 core)
fig.8.1
fig.8.2
fig.8.3
8. Installing Receiver Box
(SAFETY EDGE)
- TYPE 1