TRADEDOR TD55DM, Installation Manual

Page: 32 / 40

Tradedor TD55DM & TD55SEL Installation Guide
Programming To Receiver Box
1 Press and hold the “RADIO PROG” button
(fig. 14.5) . You will hear a beep and the red LED
alongside “C1” will illuminate, then release the
“RADIO PROG” button.
2 Enter the access code and press OK (fig. 14.6B) .
The panel will beep to confirm it has accepted
the unit.
3 Leave for several seconds and the receiver box
will beep twice to confirm end of programming.
1 Press and hold the * button (fig. 14.6A) for
3 seconds until the LED issues a slow red
flashing light.
2 Enter the master code and press OK (fig. 14.6A) .
The red LED will flash faster.
3 Enter your new access code (1 to 8 numbers
long) followed by the channel number from
1 to 4 (e.g. 5555 is the number and 1 for the
channel so 55551) and press OK
(fig. 14.6A) .
4 The LED will have a permanent green light
for 2 seconds then go out. This means it has
been programmed. If you wish for more than
1 access code, then it must be programmed
to a separate channel otherwise it will just
replace the already stored code.
Access Code
fig.14.6
A B
31
Wireless Key Pad
(ONLY AVAILABLE WITH SAFETY EDGE SYSTEM - TYPE 1)
Installation
Fit directly to the wall using the 2 fixings making sure it is level and square with the writing
at the bottom.
1 Press and hold the * button (fig. 14.6)
for 3 seconds until the LED issues a slow
red flashing light.
2 Enter the master code (factory issue 12345678)
and press OK
(fig. 14.6B) . The red LED will
flash faster.
3 Press the * button (fig. 14.6A) then enter the
new master code followed by the * button.
The LED will flash green.
4 Enter the new master code again followed by
the * button
(fig. 14.6A) . The LED will have
a permanent green light for 2 seconds then go
out. This means it has been programmed. If the
second entry doesn’t match the first, the LED
will flash red and it has not been programmed.
Mastercode
Programming Codes