TRADEDOR TD55DM, Installation Manual

Page: 25 / 40

Tradedor TD55DM & TD55SEL Installation Guide
1 Press and hold the “RADIO PROG” button (fig.12.3) .
You will hear a beep and the red LED alongside
“C1” will illuminate.
2 Insert screwdriver between the 2 pin terminals on
the board (MR) to bridge between them
(fig.12.3) .
3 Press and hold the “RADIO PROG” button (fig.12.3) .
The panel will beep 10 times and then go into 1
continuous beep. As soon as you hear this, release
“RADIO PROG” button and then remove screwdriver
from terminals and board will stop beeping.
4 Leave for several seconds and the receiver box will
beep twice to confirm end of programming.
To clear memory you will need a small screwdriver. fig.12.3
MR
1 Press and hold the “PROG” button (fig.12.4A) on the
receiver card (this is the card plugged onto the board)
until you hear a single beep.
2 Insert screwdriver between the 2 terminals on the board
(forks below “PROG” button) to bridge between them
(fig.12.4B) .
3 Press and hold the “PROG” button, the panel will beep
8 times and then go into 1 continuous beep. As soon as
you hear this release “PROG” button and then remove
screwdriver from terminals and board will stop beeping.
4 Leave for several seconds and the receiver box will beep
twice to confirm end of programming.
To clear memory you will need a small screwdriver. fig.12.4
B
A
24
Clearing Memory Of Remote Control Handsets
(SAFETY EDGE)
Clearing Memory Of Base Rail Unit
(SAFETY EDGE)