TRADEDOR TD55DM, Installation Manual

Page: 10 / 40

Tradedor TD55DM & TD55SEL Installation Guide
1 Carefully remove the cover by sliding it upwards
from the enclosure, there is a membrane ribbon
from the buttons on the box to the internal pcb
board, please remove this from the pcb board
by pulling carefully upwards.
2 Drill a 5mm hole in the wall roughly the centre
of where you would like to fix the receiver box,
then using the supplied fixings insert one of the
6mm wall plugs into the hole and screw one
of the screws into this leaving approximately
10mm of screw head and thread showing.
3 Slide the rear of the receiver box flat against
the wall and over the screw to hold in place
and make sure it is level and square while you
mark the remaining two fixings located at the
bottom of the receiver box.
4 Remove receiver box from wall and drill 5mm
holes into these two marks then place the
remaining 6mm wall plugs into the holes.
5 Slide the receiver box back over the top screw
and using fixing provided secure the bottom
two lugs in place.
6 Remove the green 4 terminal motor connector
from the board
(fig.4.1) and you will see the
letters on the board underneath.
7 Wiring as follows;
Pre wired Mains Power:
N – Neutral / Blue power cable
L – Live / Brown power cable
E – Earth / Green/Yellow
power cable
fig.4.1
Motor:
E – Green/Yellow motor cable
N – Blue motor cable (4 core)
L – Brown motor cable (4 core)
L – Black motor cable (4 core)
9
4. Installing Receiver Box
(HOLD TO RUN)
- TYPE 1