TRADEDOR TD55DM, Installation Manual

Page: 18 / 40

Tradedor TD55DM & TD55SEL Installation Guide
1 Press and hold the down button on receiver box so the curtain starts to roll down to 300mm (roughly
6 slats) from top of the guide runners.
2 Place the plastic wand in to the limit nearest the curtain of the door (fig.9.1) and turn 10 times in
the negative direction (this is marked on the head of the motor near the limits) (fig.9.2) .
3 Press and hold the up button and the door will travel to the top and should stop on its own, if the
door gets to 100mm from the top of guide runners (roughly 2 slats) and hasn’t stopped, then stop
the door and take it back down to 300mm from top of guides (roughly 6 slats) turn again 15 times
in the negative direction, take the door up and repeat until the door does stop before it gets to
100mm from top.
4 Whilst holding the up button turn the wand in the positive direction and the door will start to judder
up, keep going until there is only the last slat in the guides, take the door down a little and back up
to make sure you are happy.
5 Move the plastic wand in to the limit nearest you inside the garage (fig.9.1) and turn 10 times in the
negative direction.
6 Press and hold the down button so the door closes, it should stop before it touches the floor if this
is not the case take the door back up 300mm off the floor and turn again 15 times in the negative
direction, take the door back down and repeat until the door does stop before it reaches the floor.
7 Whilst holding the down button turn the wand in the positive direction and the door will start to
judder down, keep going until the door slats are fully compressed and a little pressure is applied
from the top (don’t apply to much pressure as this will damage the door and straps), take the door
up a little and back down to make sure you are happy.
8 Once the guide runners are fixed you will need to secure the top box, with the curtain to the closed
position you will have access to the whole top box. This is best done through the end flanges of the
header plate, either forward or sideways through the header plate itself if a between fixing
(fig.9.3) .
9 Close the door down to make sure the curtain doesn't catch anywhere and the front case is not
bowed in so as to rub on the curtain during operation, then seal down the sides and along the top
case if needed (silicon sealant is recommended).
10 Take winding stem and screw. Insert winding stem into the motor through pre-drilled hole in header
plate, then secure in place with screw on top.
PLEASE NOTE! You will see there are optional fixing positions on the straps
for them to be screwed to the barrel, these are not needed but if you would
like to do this PLEASE BE WARNED that no screws can be secured 650mm
from the head of the motor as you will damage it!
17
9. Setting Motor Limits