TRADEDOR TD55DM, Installation Manual

Page: 21 / 40

Tradedor TD55DM & TD55SEL Installation Guide
Programming Run Timers & Limits
(SAFETY EDGE)
fig.10.4 fig.10.5
fig.10.3
20
Please be aware! During set up the
motor may reach thermal cut out.
If this occurs you will need to wind
the door down manually to allow
air to pass over the barrel and cool.
This can take up to 45 mins.
If the door stops (due to thermal cut
out), or once completed the error
light is on or flashing, then you will
need to clear the memory of the
base rail unit and handsets before
restarting the whole procedure
(refer to page 24 to clear memory).
1 The curtain must be all the way down in the closed
position before starting.
2 Press and hold the “PROG” button on the receiver box
main board for 2 seconds until the red LED lights up
and stays on
(fig.10.5) . This can be found in the bottom
right next to the dipswitches.
3 Press “START” button (next to “PROG” button) (fig.10.5) .
The door will now start a setup process.
4 Door setup is complete.
1 The door will open slightly and close again.
2 The door will then open and fully stop.
3 Press & release the "START" button again
(fig.10.5) and the door will close fully.
4 Wait for several seconds and the "PROG"
light will turn off.