TRADEDOR TD55DM, Installation Manual

Page: 22 / 40

Tradedor TD55DM & TD55SEL Installation Guide
Programming Base Rail Unit
(SAFETY EDGE)
1 Once installation is complete and before
powering up, slide back down dip switch ‘2’
in the control panel, this can be found on the
four dipswitch block at the bottom middle of
the receiver board (usually blue or red)
(fig. 11.6) .
2 For access to the base rail unit on the right side
(where the writing is), push at the end of the grey
cover and slide to the left. This will give access to
the board
(fig.11.7) .
3 Fix the wireless safety edge to the centre of the
bottom slat of the door on the inside with the safety
edge fitted level and square with the writing the
correct way up .
4 Check to make sure both dip switches are down in
the base rail unit
(fig.11.8A) , these are just off centre
at the top of the unit (usually blue or red).
5 Set the sensitivity on the small dial (fig. 11.8B) to 3
to start. This can be adjusted for optimum operation
(smaller the number the more sensitive the unit is,
and the dial has to be set on a whole number).
6 Remove the plastic tab from the batteries and the
LEDs will blink on the safety edge unit.
7 Inside the receiver box press and hold the “PROG”
button on the receiver card (this is the card plugged
onto the board) until you heara single beep
(fig. 11.9) ,
then press and holdthe “PROG” button on the
wireless safety edge
(fig. 11.8C) and you will hear
another beep from the receiver box.
8 Wait several seconds until you hear 2 beeps from
the receiver box and pairing is complete.
fig.11.6
21
fig.11.7
PUSH
GREY
SECTION
11. Setting Up Wireless Safety
Edge Kit
(VELOCITY EDGE)
- TYPE 1