TRADEDOR TD55DM, Installation Manual

Page: 33 / 40

Tradedor TD55DM & TD55SEL Installation Guide
32
Wireless Key Pad
(ONLY AVAILABLE WITH SOMFY SAFETY EDGE SYSTEM)
Changing the main code
By default, the main code is
000000 on a new Digipad.
To change the main code:
1 Enter the main code and
confirm with the SET button.
2 Press the SET button until
the lower light turns on
(approximately 7 seconds).
The lower light remains on.
3 Enter the chosen replacement
code (between 4-8 characters)
and confirm with the SET
button. The lower light will
turn off & come on again.
4 Enter the code again and
confirm with the SET button.
The lower light will turn off.
The main code is recorded.
Key pad
Commissioning (for first use)
1 Open the Digipad with the
key provided.
2 Press the RESET button.
3 Check that the Digipad
has been commissioned by
pressing on one of the keypad
buttons. If the lower indicator
light comes on, the Digipad has
been commissioned. If it does
not come on, press the RESET
button again and check that it
has been commissioned.
Press button Prog on the receiver
until the indicator light comes on
permanently.
Enter 6 x 0 on keypad then press
the desired operating button
Main code forgotten
and full reset
The Digipad must be reset:
stored settings cleared, codes
and radio protocol reset to
factory settings.
To reset the Digipad:
1 Open the Digipad with the
key provided.
2 Press the ADR button
(approximately 10 seconds).
The upper light will come on
when the button is pressed
and then the 2 lights will flash
7 times. The Digipad is reset.
3 Close the Digipad.
4 Repeat the full installation
procedure: programming,
changing main code, etc.