TP-Link TL-SG5426 -, Installation Manual

Page: 357 / 499

Command Line Interface
4-116
4
Interface Commands
These commands are used to display or set communication parameters for an
Ethernet port, aggregated link, or VLAN.
interface
This command configures an interface type and enter interface configuration mode.
Use the
no form to remove a trunk.
Syntax
interface interface
no interface port-channel channel-id
interface
• ethernet unit / port
- unit - Stack unit. (Range: Unit 1)
- port - Port number. (Range: 1-26)
• port-channel channel-id (Range: 1-4)
• vlan vlan-id (Range: 1-4094)
Default Setting
None
Table 4-42 Interface Commands
Command Function Mode Page
interface Configures an interface type and enters interface configuration
mode
GC 4-116
description Adds a description to an interface configuration IC 4-117
speed-duplex Configures the speed and duplex operation of a given interface
when autonegotiation is disabled
IC 4-117
negotiation Enables autonegotiation of a given interface IC 4-118
capabilities Advertises the capabilities of a given interface for use in
autonegotiation
IC 4-119
flowcontrol Enables flow control on a given interface IC 4-120
shutdown Disables an interface IC 4-121
switchport broadcast
packet-rate
Configures the broadcast storm control threshold IC 4-122
clear counters Clears statistics on an interface PE 4-122
show interfaces status Displays status for the specified interface NE, PE 4-123
show interfaces
counters
Displays statistics for the specified interfaces NE, PE 4-124
show interfaces
switchport
Displays the administrative and operational status of an
interface
NE, PE 4-125