Toshiba TC32306FTG, Manual, Page: 9 / 102

TC32306FTG
2015-10-01 9
Pin No. Pin Name I/O Description Internal Equivalent Circuit
32 MISO
Digital
Output
Serial Data Output
In SPI Mode / SPI User Test Mode /
EEPROM User Test Mode.
MISO
Control
COM_VDD
COM_VDD
32
Control
Digital
Input
Serial Data Input
In EEPROM Mode.
Notice:
Do not supply higher voltage than the level
of COM_VDD. (For example, in the case
of too low / no power supply.) That causes
overcurrent at this pin, as the ESD
protection elements insertion between the
pin and the voltage source.
33 COM_VDD -
Common Voltage Supply
Use for 3V and 5V.
Supply to mainly control block.
-
34 DET_TMONI1
Digital
Output
Monitor 1
Monitoring internal signals (Digital), use
for system control.
At no use, open this pin.
Control
DET_TMONI1
COM_VDD COM_VDD
34
35 DATA_IO
Digital
Output
Data Output
Demodulated signal output at
RF-Receiving. Behavior of this pin is
different for each state of TC32306FTG
reset.
See Table 5-2.
Notice:
Output resistance of this pin is 10k
Ω
when
the output drive setting is "Low". Select
proper resistance value of pull-up or pull
down resistor to get enough output level of
the pin, when the output drive setting is
"Low". Or select that the output drive
setting is "High", depending on the
resistance value of the resister. About
output drive settings, see section 6.10.5.
DATA_IO
Control
COM_VDD
COM_VDD
35
Control
Control
COM_VDD
10k
Control
Low Drive
High Drive
Digital
Input
Data Input
Signal input for modulation at
RF-Transmitting. Behavior of this pin is
different for each state of TC32306FTG
reset.
See Table 5-2.
Notice:
Do not supply higher voltage than the level
of COM_VDD. (For example, in the case
of too low / no power supply.) That causes
overcurrent at this pin, as the ESD
protection elements insertion between the
pin and the voltage source.
36 IO_GND - Ground(I/O Block)
-