Toro Z Master 500 Series, Service Manual, Page: 77 / 168

5-6 Z Master 500 Gas Series Service Manual
5
ENGINE
6. Attach the two red cables to the starter solenoid (Fig.
174).
Fig 174 DSC-2964
Fig 176 DSC-2971
8. Install the fuel line to the engine and install a hose
clamp. Turn the fuel shut off valve to the ON
position (Fig. 176).
7. Install hydrostatic pump drive belt, using a pry bar to
relieve the tension on the spring loaded idler pulley
(Fig. 175).
9. Install the throttle and choke cables to the
throttle linkage. Position the throttle lever so it is
approximately 1/2” (12.7mm) from the full throttle
position. Make sure the choke lever is pushed down
to the OFF position. Then tighten both cable clamps
(Fig. 177).
Fig 175 DSC-2963
Fig 177 DSC-2959
A Throttle Cable B Choke Cable
A Fuel Valve B Fuel Line Clamp
A
B
A
B