Toro Greensmaster 3420 TriFlex, Service Manual

Page: 240 / 360

Greensmaster 3320/3420 Page 6 -- 90 Electrical System
Generator Assembly (Greensmaster 3420)
1. Generator assembly
2. Square key
3. Generator pulley
4. Square head screw (2 used)
5. Generator plate
6. Flange head screw (5 used)
7. Washer (2 used)
8. Torsion spring
9. Idler bracket
10. Retaining ring
11. Grease fitting
12. Generator belt
13. Flange nut
14. Idler pulley spacer
15. Flange head screw (5 used)
16. Bell housing
17. Flange nut (5 used)
18. Engine pulley
19. Lock nut (2 used)
20. Coupling flange
21. Rear engine mount
22. Thrust washer (2 used)
23. Cap screw (2 used)
24. Flange head screw (6 used)
25. Washer
26. Flange head screw (5 used)
27. Cap screw
28. Idler pulley
29. Generator guard
30. Dirt exclusion washer (2 used)
31. Flange bushing (2 used)
32. Engine assembly
33. Washer head screw (4 used)
Figure 106
2
7
22
19
17
6
13
20
18
12
29
1
5
9
3
8
21
16
11
23
27
24
4
10
26
15
7
24
14
25
30
28
30
31
31
32
33
FRONT
RIGHT
90 to 110 in--lb
(10.2 to 12.4 N--m)
70 to 80 in--lb
(8.0 to 9.0 N--m)
NOTE: If electrical problems exist with the generator
assembly, a fault should have occurred that would be in-
dicated by a flashing diagnostic light on the console (se-
rial number below 312000000) or fault indicator on the
InfoCenter (serial number above 312000000). Before
considering that generator service work is necessary,
check for any existing fault codes that indicate problems
with the generator.
Removal (Fig. 106)
1. Park machine on a level surface, lower cutting units,
stop engine, apply parking brake and remove key from
ignition switch.