TMC TMC 1000E, Operation Manual

Page: 139 / 182

Injection Molding Machine Chapter 7
7-2
V3.0
CAUTION
Center height of nozzle has been adjusted upon factory delivery
，
unless injection
base deflection is confirmed
，
it is better not to make any adjustment arbitrarily.
Machine Model 60E 90E 120E 150E 200E 250E 350E
Locating ring
φ
100
×
φ
150
×
15 depth
φ
150
×
φ
200
×
15 depth
Machine Model 500E 750E 1000E
Locating ring
φ
150
×
φ
250
×
15 depth
φ
200
×
φ
300
×
15 depth
1.2 Adjustment of moving platen shoes
The purpose of this adjustment is to make the four tie bar holes
，
fixed platen and moving platen to be
on the same central line. Adjustment procedures are as follows
：
Ａ
) Confirm that no mold is set between platens.
Ｂ
) Loosen the nut that secures 1251
，
pull the shoe out.
Ｃ
) Mount a dial gauge on moving platen, measure the vertical displacement of tie bar.
Ｄ
) Pushes the shoe into mating slant slot by hand.
Ｅ
) Tighten up adjusting bolt and nut until dial gauge reads 0.02 more.
Ｆ
) Apply sufficient grease.
Ｇ
) Perform clamp open/close with maximum stroke for several times to confirm that height has been
properly adjusted.
Shoe
Fixing bolt