TMC TMC 1000E, Operation Manual

Page: 55 / 182

Injection Molding Machine Chapter 4
4-12A
V3.0
2.4.1Mold Compression (for H2-SE model)
On
於
MOLD ADJ. screen
，
press F2 to enter this screen.
V1: 0/ 0 0/ 0 V2:
0/ 0 P1: 0/ 0 P2: 100.0mm
50.0mm 110.0mm
10.0mm
STATUS
M:
10D05M10Y
10h25m10s
20°C 1W
INJ. END MOLD COMPRESS OFF
F2 F1 F3 F4 F5 F6 F7 F8
MENU
11
A
V %
PBar
1 2 3 4 5 1
50 50 50 50 50
35 50 75 100 140
C
D
B < 16.5>
CLAMPING STATUS : 0 TON
PRESENT MOLD PRESSURE : 0 Bar
MOLD
COMPRESS DIE HEIGHT
AUTO
TONNAGE
AUTO
LOG
CHANGE
LOG
ALARM
SUPPORT
MOLD
COMPRESS START INJ.PT.
畫 面
3-8A
This sequences can reduce injection pressure during molding process
，
therefore
eliminate product warpage and increase finished parts reproducibility
，
mold
structures has to be suitable for compression sequences.
Set
Ａ
OFF
， Ｂ
position to 0.0 when it is not used.
Ａ
INJ. END MOLD COMPRESS
：
when set ON
，
compression sequences start at
transfer position
，
mold lock pressure increases according to setup point
，
hence
clamping force also increases to compress molded parts.
Ｂ
COMPRESS START INJ.PT.
：
compression sequences start when injection
position reached this set position
，
mold lock pressure increases according to setup
point
，
hence clamping force also increases to compress molded parts.
Ｃ
V%
：
speed command of mold closed
。
Ｄ
PBar
：
pressure command for mold closed
，
it must be bigger one after another.
Compression sequences run according to speed and pressure commands
，
when actual lock-up pressure
reached setup pressure
，
sequence shifts to next step.