TMC TMC 1000E, Operation Manual

Page: 99 / 182

Injection Molding Machine Chapter 4
V3.0
4-56
Ｄ
) Press manual injection key to perform injection operation.
Ｅ
) Press manual charge key (One Touch)
，
starts charging to setting position.
Ｆ
) Press manual suck back key to perform suck back operation.
Ｇ
) Press manual carriage retract key to perform carriage retract operation.
Ｈ
) Press manual clamp open key until clamp open is completed.
Ｉ
) Press manual ejector advance key to perform ejector advance operation.
Ｊ
) Press manual ejector retract key to perform ejector retract operation.
4.2 Semi automatic operation
After
completion of manual operation
，
open front operator gate
，
do the following semi-auto operation
procedures:
Ａ
) On clamp close screen
，
set INTERVAL T. properly.
Ｂ
) On charge screen set CHA. END position to 0. (Refer to following figure)
Ｃ
) On charge screen set SUCK B. position properly. (Refer to following figure)
Ｄ
) Press semi-auto key .
Ｅ
) Close front operator gate
，
press and manual clamp close key (One Touch).
Ｆ
) Upon end of cycle
，
open front operator gate
，
then close it again
，
and press and release manual
clamp close key again(One Touch)
，
machine will perform next cycle.
PTmm
Pbar
V%
V1: 0/ 0 0/ 0 V2:
0/ 0 P1: 0/ 0 P2: 100.0mm
50.0mm 110.0mm
1.0mm
ACTION STATUS
M:
03D05M07Y
10h2510s
20°C 3W
SUCK BACK
COOLING T.
ON
< 20.0> 0.0
CHARGE MONITOR T.
CHARGE DELAY T.
PROFILE
F2 F1 F3 F4 F5 F6 F7 F8
MENU
05
2 1
BPbar
CH. END
0.0
SUCK B.
F.W. END B.W. END
< 15.0> 0.0
< 0.2> 0.0
INJ END
1 2 3
10.0 0.0 0.0
100 100 100
0
0 0
V%
Pbar
PTmm
50 50 50
+100.0
50
40
150.0
80
70 70 70
30.0 10.0
80 10
B.P.
PURGE
AUTO CHANGE
LOG MOLD
SUPPORT FUNCTION
PROD.
MANAG.
WGT. g
60.0
CARRIAGE
B.P ACT 0
RPM 0
SUCK
BACK
CHARGE
PARAMETER
Screen 4-39