Thompson ViBE EM4000, User Manual

Page: 68 / 350

Chapter 4 ’Web Browser Interface’ — Quick configuration
56 ViBE EM4000 — Release 1.10
User Manual — 46073586AB02
Quick configuration
To rapidly configure the Encoder, please follow these steps:
Table 4-3. Steps for rapidly configuring the Encoder
Step Section
1.
Define the number of
output TS(s)
Refer to section ’Configuring the number of TSs at
Encoder output’ on page 63.
2.
Configure the output IP
interfaces
Refer to section ’Configuring LAN/WAN network
interfaces’ on page 64.
3.
Configure the TS stream
and output IP
encapsulation
Refer to section ’Configuring TS streams and IP
encapsulation’ on page 67.
4.
Load a Predefined
in-factory Configuration
Refer to section ’Predefined Configurations’ on
page 99 and section ’Configurations predefined
in-factory (WBU_ISOG Conf)’ on page 100.
5.
Fine tune the configuration
to actual Encoder use
Refer to section ’Setting a Basic encoder’ on page 72.