Thompson ViBE EM4000, User Manual

Page: 41 / 350

Chapter 2 ’Installation and Startup’ — Performing the Initial Settings
ViBE EM4000 — Release 1.10 29
User Manual — 46073586AB02
Setting Initial Parameters
Commands Relating to IP Parameters
The following procedure is used to set the IP parameters of the Control 1
& 2 port located on the ViBE EM4000’s rear panel.
Displaying IP Parameters (ipdisp)
To display the Encoder IP parameters, type
ipdisp
after the ViBE prompt:
Figure 2-10. Displaying Encoder IP parameters - ipdisp command
Editing IP parameters (ipset)
To edit the Encoder IP parameters, type
ipset
after the
ViBE
prompt:
Figure 2-11. Editing Encoder IP parameters - ipset command
„
Enter the new value of the parameter(s) to be edited and press
Return
.
If the parameter does not require editing, you do not need to enter its
value. Just press
Return
straight after ? to confirm the current value.
If the IP gateway address is not used, type
0.0.0.0
.
„ Type
y
after Sure to modify ? if you wish to confirm the new
configuration or
n
if you wish to keep the previous configuration.
„
The changes will be acknowledged after the Encoder has been
rebooted.
„
The Encoder must be connected to the network during the boot
which follows IP address configuration to facilitate detection of
MAC/IP address pair changes.