Thompson ViBE EM4000, User Manual

Page: 59 / 350

Chapter 3 ’Front Panel Operation’ — Screen Description
ViBE EM4000 — Release 1.10 47
User Manual — 46073586AB02
„ Procedure for recalling a configuration
™ Select the configuration to be recalled on the Recall screen using
the
Ð
or
Ï
keys.
™ Confirm your choice by pressing OK.
If the recalled configuration is a Basic encoder type
configuration, the following screen will be displayed:
Figure 3-14. Recall, Basic encoder type configuration screen
™ Select the Basic encoder (ENCx) to be configured using the
Ð
or
Ï
keys.
™ Confirm your choice by pressing OK.
Regardless of the type of recalled configuration, the Confirm
screen will be displayed:
Figure 3-15. Recall, Confirm screen
™ Press OK to enable the recall or ESC/HOME to exit this screen.
At the end of the operation and if the recall was successful, the
following screen will be displayed:
Figure 3-16. Recall, recall successful screen
An error message will be displayed in the event of failure.
ZZ EQU: ........ ZZ : Used to indicate the ID of the configuration.
EQU (or ENC ): Used to indicate the type of
configuration ( EQU = chassis, ENC = Basic encoder).
-------: Name of the configuration as set on creation.
RECALL Preset ZZ ENC1
Select Target Id: 1
Use Up/Down, then OK
RECALL Preset ZZ XXX
Do you Confirm Recall?
No=ESC Yes=OK
RECALL Preset ZZ XXX
Recall Done, Press OK