Thermo Scientific Vanquish VH-P10-A-02, Operating Manual

Page: 73 / 238

5 • Installation
Vanquish Pumps (VH-P10-A-02) Operating Manual Page 73
b) With your other hand, insert the tubing between the lever and
the rotor and wind it around the rotor.
c) Release the lever.
d) Check that the peristaltic tubing is properly inserted in the
tubing holders. If it is not, push the tubing into the holders.
Make sure that the tubing is not pinched or squeezed in the
holders.
e) Check that the right tubing connector rests on the tubing holder.
If it does not, push the tubing connector onto the holder.
2. In the autosampler, the seal wash line to the pump and the seal
wash inlet port (right tubing connector) are interconnected.
Disconnect the seal wash line (clear silicone tubing) from the seal
wash inlet port (right tubing connector).
Figure 22: Seal wash connections in the autosampler
3. Route the seal wash line from the seal wash outlet of the metering
device through the tubing guides to the peristaltic tubing in the
pump.
4. In the pump, connect the seal wash line to the tubing connector on
the free end of the peristaltic tubing.
No. Description
1 Seal wash inlet port
(right tubing connector)
1a Seal wash line to reservoir
2 Seal wash outlet on the
metering device head
2a Seal wash line to pump