Dionex Reagent-Free Controller
64
Doc. 031880-04 1/12
•
For DX-120 systems
: Disconnect the suppressor power source
cable from the
SRS A
connector inside the DX-120. Disconnect
the other end of the cable from the suppressor cable. Remove the
power source cable from the DX-120 and store the cable for later
use.
3. Route the
AES/SRS
cable (see Figure 58) from the Dionex RFC to the
suppressor and connect it to the cable from the Atlas or SRS
suppressor. To connect the cables, push them together.
NOTE
The EG-1
and
CR-TC
cables are connected during
the eluent generator installation procedure
(Section B.8).
4. If you are installing a Dionex RFC in a DX-320, DX-500, or DX-600
5. If you are installing a Dionex RFC in a DX-120, go to Section B.3.
B.2
DX-320, DX-500, and DX-600 TTL Connections
NOTE For DX-120 TTL connections, go to Section B.3.
Figure 59. DX-320, DX-500, and DX-600 TTL Connections Overview
NOTE:
If
TTL-1 OUT
is already in use,
connect the gradient
TTL cable to any
available TTL or
relay on the pump or
detector.