Thermo Scientific Dionex ICS-5000, Operator'S Manual

Page: 365 / 482

9 • EG Service
Doc. 065342-06 12/11
349
d. EG panel: Enter 50 mM in the Target Concentration field. This
turns on the power to the EGC, also.
e. Condition the analytical EGC for 30 minutes.
3. Turn off the EGC and CR-TC power.
4. Turn off the pump flow.
Completing the Analytical EGC Installation
1. Twist the ring on the EGC electrical cable counterclockwise to loosen it,
and then pull the cable straight out of the
EGC 1
(or
EGC 2
) bulkhead
connector.
2. Remove the backpressure tubing from the waste container and remove the
waste container.
3. Replace the 10-32 plug in the EGC vent opening.
4. Lift the EGC out of the holder, turn it upside down, and place it on the
drip tray in the service position (see Figure 9-17 ).
5. Disconnect the backpressure coil from the EGC
OUTLET
port.
6. Connect the
EGC OUT
line to the
OUTLET
port.
7. Turn the EGC right-side up, and check for bubbles in the eluent
generation chamber. If necessary, shake and tap the cartridge to remove
bubbles.
8. Install the EGC in the holder. Remove the 10-32 plug from the vent
opening and reinstall the luer adapter and vent line.
9. Reconnect the EGC electrical cable.
9.15 Replacing the CR-TC
The CR-TC replacement procedure consists of:
•
Removing the old CR-TC (see Section 9.14.1 )
•
Installing and hydrating the new CR-TC (see Section 9.15.2 )
•
Completing the plumbing for the new CR-TC (see Section 9.15.3 )