Thermo Scientific DCT6088, User Manual

Page: 42 / 121

Operating & Configuring the Flowmeter
Flowmeter Configuration
Flowmeter configuration is accomplished using the setup menus. Some
setup menus allow a numeric value to be entered, and others offer non-
numeric selections. In non-numeric setup menus, an asterisk is displayed to
the left of the selected currently entered in the flowmeter, as shown in the
figure below.
Flowmeter
Configuration
Figure 4–2.
There are two ways to access the setup menus: via direct access or through
the menu structure.
Direct Menu Access
The unique two-digit address for each setup and diagnostic menu enables
the user to directly access the desired menu. The menu addresses are listed
in Table 4–1. To use them, follow the two steps below.
1. Press MENU , and the letter M appears in the lower right corner of the
display.
2. Enter the desired two-digit address.
Note The address must be entered while the M is displayed (within
approximately 4 seconds). If the M is no longer displayed, press
MENU again followed by the two-digit address. ▲
3. If the setup menu requires a numeric entry, use the numeric keys to
enter the value and press
ENTER to accept the value. If you need to
change the entry, press ERASE . If the setup menu offers a non-numeric
selection, press ENTER , and the asterisk changes to a flashing cursor.
Use the arrow keys to scroll through the available selections. When the
cursor is to the left of the desired selection, press
ENTER .
4. Complete the process by accessing a Primary display (menus 00
through 04).
Note The flowmeter will not use the new parameters until you access a
Primary display. ▲
4-2 DCT6088 User Guide Thermo Fisher Scientific