![background image](http://html1.mh-extra.com/html/thermo-king/sb-210/sb-210_operators-manual_1104425131.webp)
Optional Rear Remote Control Panel
130
Rear Remote Control Panel
Functions
The Rear Remote Control Panel functions that are available are
determined by the setting of the Rear Remote Control and Rear
Remote Control Action features in the Guarded Access Unit
Configuration menu. Contact your Thermo King dealer for
information about programming these features.
When the unit is turned on at the Rear Remote Control Panel
either the Standard Display or [STAnd by] will appear on the
display.
Run
If the Rear Remote Control Action is set to RUN the unit will
automatically start and run as required when the remote control
ON key is pressed. Pressing the Rear Remote Control Panel
OFF key will power down the control system.
If the control system is powered up from the Rear Remote
Control Panel the Standard Display will appear in both the
remote control panel display and the unit HMI control panel
display. In addition to turning the unit on and off, the Rear
Remote Control Panel allows the following:
•
Change the Setpoint
•
Select Cycle-Sentry or Continuous Mode
•
Display discharge air temperature
•
Display and clear alarm codes
•
Initiate a manual defrost cycle
•
Send a Start of Trip marker to the data loggers
•
Initiate a Pretrip Test
Optional Rear Remote Control Panel
130
Rear Remote Control Panel
Functions
The Rear Remote Control Panel functions that are available are
determined by the setting of the Rear Remote Control and Rear
Remote Control Action features in the Guarded Access Unit
Configuration menu. Contact your Thermo King dealer for
information about programming these features.
When the unit is turned on at the Rear Remote Control Panel
either the Standard Display or [STAnd by] will appear on the
display.
Run
If the Rear Remote Control Action is set to RUN the unit will
automatically start and run as required when the remote control
ON key is pressed. Pressing the Rear Remote Control Panel
OFF key will power down the control system.
If the control system is powered up from the Rear Remote
Control Panel the Standard Display will appear in both the
remote control panel display and the unit HMI control panel
display. In addition to turning the unit on and off, the Rear
Remote Control Panel allows the following:
•
Change the Setpoint
•
Select Cycle-Sentry or Continuous Mode
•
Display discharge air temperature
•
Display and clear alarm codes
•
Initiate a manual defrost cycle
•
Send a Start of Trip marker to the data loggers
•
Initiate a Pretrip Test
Summary of Contents for SB-210+
