![background image](http://html1.mh-extra.com/html/thermo-king/sb-210/sb-210_operators-manual_1104425059.webp)
Operating Instructions
58
Starting the Diesel Engine
Diesel engine preheats and starts automatically in both
Continuous Mode and CYCLE-SENTRY mode. The engine
will preheat and start if necessary when the unit is turned on.
The engine preheat and start will be delayed in
CYCLE-SENTRY mode if there is no current need for the
engine to run. If a key or sequence of keys are pressed on the
controller before the engine starts, the engine will preheat and
start approximately 10 seconds after pressing the last key.
See “Turning Unit On” on page 51.
NOTE: Run a pretrip test if the unit has not been used
recently. See “Pretrip Tests” on page 104.
Unit Fails To Start
If the engine does not start and the Alarm Icon appears on the
display, take the following steps.
1.
Check for and correct any alarm conditions. See “Viewing
and Clearing Alarms Screen Sequence” on page 87.
2.
Clear all alarms. See “Viewing and Clearing Alarms
Screen Sequence” on page 87.
3.
Press the
O
FF
key to turn the unit off.
4.
Press the
O
N
key to turn the unit on.
5.
The controller will go through the start up screens and
then after a 10 second delay the unit will start
automatically.
6.
If the engine will still not start, turn the unit off. Determine
and correct the cause for not starting.
7.
Repeat the procedure.
CAUTION: The engine may start automatically any
time the unit is turned on.
WARNING: Never use starting fluid.
Operating Instructions
58
Starting the Diesel Engine
Diesel engine preheats and starts automatically in both
Continuous Mode and CYCLE-SENTRY mode. The engine
will preheat and start if necessary when the unit is turned on.
The engine preheat and start will be delayed in
CYCLE-SENTRY mode if there is no current need for the
engine to run. If a key or sequence of keys are pressed on the
controller before the engine starts, the engine will preheat and
start approximately 10 seconds after pressing the last key.
See “Turning Unit On” on page 51.
NOTE: Run a pretrip test if the unit has not been used
recently. See “Pretrip Tests” on page 104.
Unit Fails To Start
If the engine does not start and the Alarm Icon appears on the
display, take the following steps.
1.
Check for and correct any alarm conditions. See “Viewing
and Clearing Alarms Screen Sequence” on page 87.
2.
Clear all alarms. See “Viewing and Clearing Alarms
Screen Sequence” on page 87.
3.
Press the
O
FF
key to turn the unit off.
4.
Press the
O
N
key to turn the unit on.
5.
The controller will go through the start up screens and
then after a 10 second delay the unit will start
automatically.
6.
If the engine will still not start, turn the unit off. Determine
and correct the cause for not starting.
7.
Repeat the procedure.
CAUTION: The engine may start automatically any
time the unit is turned on.
WARNING: Never use starting fluid.
Summary of Contents for SB-210+
