![background image](http://html1.mh-extra.com/html/thermo-king/sb-210/sb-210_operators-manual_1104425137.webp)
Optional Rear Remote Control Panel
136
Turning the Unit On or Off
(Configured for STAND BY
Operation)
The control system is turned on by pressing the ON key and off
by pressing the OFF key. When the ON key is pressed the
remote display briefly shows all segments and then STAnd by
as shown below. A stand by message will also appear on the
unit HMI control panel display. The setpoint can be changed
but the unit will not start and run. Only the Select Key, Enter
Key and Up and Down Arrow Keys are functional. The unit
can be started and run by pressing the unit HMI Control Panel
ON key.
Figure 101: Stand By Display
IMPORTANT: To change the setpoint, press the Select Key to
show the Remote Standard Display. The setpoint can now be
changed as shown on the next page.
Turning the Unit On and Off
(Configured for RUN Operation)
The unit is turned on by pressing the ON key and off by
pressing the OFF key. When the ON key is pressed the remote
display briefly shows all segments and then COn FIg as the
control system initializes. Then the Remote Standard Display
will appear as shown below. The unit will start and run if
necessary.
Figure 102: Standard Display
Optional Rear Remote Control Panel
136
Turning the Unit On or Off
(Configured for STAND BY
Operation)
The control system is turned on by pressing the ON key and off
by pressing the OFF key. When the ON key is pressed the
remote display briefly shows all segments and then STAnd by
as shown below. A stand by message will also appear on the
unit HMI control panel display. The setpoint can be changed
but the unit will not start and run. Only the Select Key, Enter
Key and Up and Down Arrow Keys are functional. The unit
can be started and run by pressing the unit HMI Control Panel
ON key.
Figure 101: Stand By Display
IMPORTANT: To change the setpoint, press the Select Key to
show the Remote Standard Display. The setpoint can now be
changed as shown on the next page.
Turning the Unit On and Off
(Configured for RUN Operation)
The unit is turned on by pressing the ON key and off by
pressing the OFF key. When the ON key is pressed the remote
display briefly shows all segments and then COn FIg as the
control system initializes. Then the Remote Standard Display
will appear as shown below. The unit will start and run if
necessary.
Figure 102: Standard Display
Summary of Contents for SB-210+
