![background image](http://html1.mh-extra.com/html/thermo-king/precedent-c-600/precedent-c-600_operators-manual_1104429124.webp)
Optional Rear Remote Control Panel
123
When in STAND BY, the unit will not start and run and a
defrost cycle or Pretrip Test cannot be started.
If the control system is powered up from the remote control
panel a stand by message will appear in both the remote control
panel display and the unit Control Panel display as shown in
Figure 156 and Figure 157.
Figure 156: Rear Remote Control Panel Display
Figure 157: Unit Control Panel Display
When the StAnd bY display is shown, press the Select Key to
show the Remote Standard Display. When the remote standard
Display is shown, the setpoint and operating mode can be
changed, the discharge air temperature can be displayed and
alarms can be viewed and cleared. In addition, a Start of Trip
can be sent to the data loggers.
After the last key is pressed, the display will return to the
StAnd bY display shown in Figure 158 in about 10 seconds.
Figure 158: Press Select Key