TEUPEN LEO 15 GT, Translation Of The Original Operating Instructions

Page: 163 / 208

11
EN
1. DISCHARGE FUEL (See Fig.
8 8 8 8 8
-
q q q q q
)
If you do not use the engine more than 1 month, discharge
fuel to prevent gum in the fuel system and carburetor parts.
■
Remove the fuel cup, place it over a container and open
the fuel cock to discharge fuel from the fuel tank.
■
Remove the drain screw of the carburetor float chamber
and discharge fuel.
2. ENGINE OIL
■
Change the engine oil with fresh oil.
■
Remove the spark plug, pour about 5 cc of engine oil
into the cylinder, slowly pull the starter handle of the
recoil starter 2 or 3 times, and reinstall the spark plug.
3. CLEAN AND STORE
■
Slowly pull the recoil starter handle until resistance is
felt and leave it in that position.
■
Clean the engine thoroughly with an oiled cloth, put the
cover on, and store the engine indoors in a well
ventilated, low humidity area.
4. BATTERY CHARGING
WARNING
Flame Prohibited
1. FUNCTION OF OIL SENSOR
The engine will stop automatically when the oil level falls
below the safety limit. The engine cannot be started unless
the level is raised above the prescribed limit. (See Fig.
2
-
w
)
2. RESTARTING
(1) Fill the crankcase with oil up to the proper level.
(2) As for restarting and operating the engine, refer to section
“6. OPERATING YOUR ENGINE” on page 8 .
■
Check the wire connector from the engine. It must be
connected securely to the wire from oil sensor.
■
When selecting the engine oil, refer to page 5 for the
recommended oil.
10. EASY TROUBLESHOOTING
■
Wipe out spilled fuel carefully before testing.
Place spark plug as far away from spark plug
hole as possible.
■
Do not hold spark plug by hand while pulling
recoil starter.
WARNING
NOTE
The engine with oil sensor will stop automatically when
the oil level falls below the prescribed limit.
Unless the oil level is raised above the prescribed limit,
the engine will stop immediately after starting.
3. Is the spark plug wet with gasoline?
(1) Is the fuel cock opened?
(2) Choke (close choke lever) and pull the starter handle
five or six times. Remove the plug and check if its
electrode is wet. If the electrode is wet, fuel is well
supplied to your engine.
(3) When the electrode is dry, check where the fuel stops.
(Check the fuel intake of the carburetor.)
(4) In case the engine does not start with well supplied fuel,
try using fresh fuel.
4. Is the battery well charged?
If the battery for the electric starter is discharged, the engine
will not start.
Pull the starter handle slowly and check if resistance is felt.
If little force is required to pull the starter handle, check if
the spark plug is tightened firmly. If the spark plug is loose,
tighten it.
2. Is there enough compression?
8. PREPARATIONS FOR STORAGE
9. OIL SENSOR INSTRUCTIONS
(OPTIONAL)
WHEN ENGINE WILL NOT START :
Perform the following checks before you take the engine to
your Robin dealer. If you still have trouble after completing
the checks, take the engine to your nearest Robin dealer.
1. Is there a strong spark across the
electrode ?
(1) Is the stop switch at position “ I ” (ON)?
(2) Remove and inspect the spark plug.
If the electrode is fouled, clean or replace it with new
one.
(3) Remove the spark plug and connect it to the plug cap.
Pull the starter handle while grounding spark plug against
engine body. Try with a new spark plug if the spark is
weak or there is no spark.
The ignition system is faulty if there is no spark with a
new spark plug.
■
The battery discharges itself even when not connected,
therefore it is necessary to recharge it once a month.
WARNING
Flame Prohibited
EXseries̲en̲EU2484.pmd 07.12.13, 0:54 AM Page 11 Adobe PageMaker 7.0J/PPC