TEUPEN LEO 15 GT, Translation Of The Original Operating Instructions

Page: 133 / 208

No. Description
42 Machine swivelled too far with one-side wide bracing or resolver transducer
defect
43 Machine swivelled too far with wide bracing or resolver transducer defective.
44 Maximum swivel range exceeded or rotary transducer is defective.
45 Compare error of swivel angle. Check resolver transducer or calibrate angle sen-
sors.
46 Check the position of the angle sensors. Is required reset.
47 Telescopic arm too wide or resolver transducer defective.
48 Check pressure sensors.
49 Check pressure sensor for reliable values.
50 The pressure measured for this situation is too low. The telescopic arm is braced
or the pressure sensor is defective.
51 Position switch for telescoping in telescopic arm defective.
52 Software error / hardware error.
53 Software error / hardware error.
54 Hardware error SPI real time clock.
55 Machine was not switched off for several days and must be restarted.
56 Different input information of the safety functions between the master and slave.
57 Different input information of the safety functions between the master and slave.
58 Different input information of the safety functions between the master and slave.
59 Different input information of the safety functions between the master and slave.
60 Check safety relay 1 monitoring contact
61 Check safety relay 2 monitoring contact
62 Check safety relay 3 monitoring contact
63 Check safety relay 4 monitoring contact
64 Telescopic arm too wide or resolver transducer defective.
65 Load curve saved wrong. Check load curves and save again.
66 Load curve deviation too far from base curve. Check load curves and save again.
67 Load curve values wrong. Check load curves and save again.
68 Angle values in load curve do not match specifications. Check load curves and
save again.
69 The amount of outriggers does not match the specification. Check load curves
and save again.
Faults
13.02.2013 Aerial access platform Leo15GT 2012 129