![background image](http://html.mh-extra.com/html/tesa/micro-hite/micro-hite_instruction-manual_1090543019.webp)
Instruction manual for MH & MH+M
19
2.12 Information LED
For more comfort during measurements, an informative LED has been placed at the end of the
probe support mounting shaft. This LED changes its colour according to the current action and
the measurement pertinence.
This system developed by TESA is patented.
For further details, see this
2.13 Interface &
displayed values
The ergonomic software has been designed to avoid any ambiguous situations. At any time,
the displayed values correspond only to a measurement or a calculation and never to the probe
position (except in mode “scanning” or
Max, Min, Δ
).
Results of last measurement in red, previous measurement results in green.
In order to avoid any reading errors of the displayed values on the screen,
only measurement results or calculations are visible. Except for a few specific
modes, your height gauge will not display the current value of the position of
the probe.
2.14 Printer
An USB matrix printer especially designed for your height gauge is available as an optional
accessory.
Its installation does not require any special intervention. Each MICRO-HITE or MICRO-
HITE+M is directly compatible with this printer, which can be connected to an USB port on the
back of the control panel at any time.