Instruction manual for MH & MH+M
79
2. Displace the probe slightly to one side of the culmination point (visually).
3. Move the probe up or down in order to establish contact with the workpiece.
4. Once the contact established, continue to apply pressure in order to place the strain
gauge in the green zone. At that moment, the software has to detect that you want to
measure a culmination point and will ask you to move in the bore.
If the selected mode is not the right one (bore instead of axis measurement, or vice
versa), this is the moment to select the right procedure using the keyboard. Note that
the procedure selected will be stored in the memory for the next measurement.
5. Once the minimum (or maximum) point passed, the software will issue a beep. The
probe is now located on the opposite side.
6. It is now possible to release the pressure on the probe and to remove it from the
workpiece. This action finishes the process.
