Instruction manual for MH & MH+M
150
1
The probe is inserted into
the groove manually by
moving the part or the
instrument
2
A probe hit has the effect of
starting a countdown until
the probe will be moved to
the next measurement
zone.
3
During the countdown, the
operator has time to
withdraw the probe from
the part to avoid any
subsequent collision.
4
The countdown is finished,
the probe automatically
moves to the next
measurement zone
5
The probe has stabilised at
a height close to the
measurement, a new
countdown was started
6
During the countdown, the
user can position the probe
appropriately over the area
to be measured
7
The probe is now in a good
position, the countdown is
not finished
8
Once the countdown is at
0, the probe goes down to
measure a point
If the distance between two measurement zones (two measurement points)
is small enough, only one countdown will be used in order to save time.
22.11 Results
Once you have run a sequence and reached the end of it, a result page is automatically
displayed.
