Instruction manual for MH & MH+M
77
For the explanation below, we consider that the LED option has been previously activated
in the menu
System options
, which is available from the main page of the software that
can be accessed at any time via the key
.
There are four different colours that the LED will display. Each one of it represents different
information.
Colour
Description
The software is ready for measurement. The process can start.
The probe is moving in the wrong direction.
The probe is located at the inflection point or very close to it.
The probe is moving in the right direction.
Do not displace the workpiece too quickly.
Below you will find an example describing the different steps of measuring a minimum
internal culmination point. Of course all other types of culmination points can be measured
in a similar way.
Step
Schema
Action
LED
1
Place the probe in the bore.
Not
turned
on
2
Slightly move the probe, so that it is visually placed
on one side of the culmination point.
Not
turned
on
3
Move the probe down, so that it gets in contact with
the workpiece. Once the probing force is in the
middle of the mechanical range of the carriage,
block the locking ring.
4
-
Observe the help image on the right side of the
screen and verify if the software suggests to
measure an internal culmination point. If that is not
the case, press the corresponding keyboard key to
change the process.
