Snappi System User Manual
Document No: 053-05 v29
Page 15 of 75
December 2015
Snappi System User Manual.doc
Fig 4.2.4 Right: The brake in the fully locked
position.
Fig 4.2.4
Fig 4.2.5
To release the pin brake, hold the pushchair
and place your foot underneath the brake
bar as shown (see Fig 4.2.5, left). Lift the
bar as far as it will move to ensure the pins
are clear of the locking rings.
Warning:
When operating the brake mechanism ensure that you always keep a firm hold of
the pushchair and keep your hands well away from the brake mechanism.
Do not leave the pushchair on a slope, even with the brake on. Always ensure that
the pushchair is on level ground to prevent risk of injury to the occupant.
4.2C Tyres:
As standard the Snappi pushchair is supplied with solid tyres, however pneumatic tyres
are also available as an option. If your pushchair is supplied with pneumatic tyres these
need to be regularly checked and inflated if necessary using a hand or foot pump. The
operating pressure for the tyres is 36 PSI (note: do not inflate the tyres above 36 PSI). Do
not use high pressure air lines or mechanical pumps as used in garages, to inflate the
tyres.
