Snappi System User Manual
Document No: 053-05 v29
Page 41 of 75
December 2015
Snappi System User Manual.doc
Fig 6.4.5
The central strap is designed as an
additional security measure to keep the hood
attached to the frame and we would
recommend that this is used at all times.
Ideally the clips should be located to avoid
the weld on the frame. However, if it is
necessary to position one of the clips on the
weld the strap must be used to secure the
hood. Once you have clipped the hood onto
the vertical tubes, the straps should be
threaded in between the front and back
plates, and secured with the attached cam
buckle (See Fig.6).
Hold the hood by the two tubes and align the
black clips with the tubes on the back of the
Snappi seat (See Fig 6.4.5). Press each clip
on to the seat tubes, positioning them so that
the hood is at an appropriate height for the
occupant. The clips can be attached
anywhere on the vertical tubes.
Fig 6.4.6
Fig 6.4.7
Note: If there is insufficient gap between the
plates to thread the strap, it may be
beneficial to loosen the backrest height
adjustment thumbscrews and lateral trunk
thumbscrews (please see sections 5.1.3 and
5.1.4 in this manual for detailed instructions).
Once the hood is securely fastened at the
back you can adjust the hood forward. You
may need to loosen the thumb screws again
if you tightened them after unfolding the
tubes.
