Snappi System User Manual
Document No: 053-05 v29
Page 42 of 75
December 2015
Snappi System User Manual.doc
Fig 6.4.8
Adjust the hood to the desired angle and
then tighten the thumb screws to hold the
hood securely in place. Each time you wish
to change the angle of the hood, you must
first loosen the thumb screws, adjust the
angle as desired and then ensure that you
tighten the screws to prevent them falling off.
To fit the plastic Rain Shield, unfold it from
its packaging and place it over the Sun Hood
with the Velcro flap facing the front (See Fig
6.4.1). Then tuck the elasticated edge under
the footrest (See Fig 6.4.9).
Fig 6.4.9
Fig 6.4.10
Tuck the back flap down inside the push
handle and feed the velcroed edges through
inside the frame. This will make it easier to
stick them to the other velcroed edge.
